A small amount of tail gas is discharged during the use of the diesel generator. If the tail gas is directly discharged, it will cause certain pollution to the surrounding area. According to environmental protection requirements, and in order to further improve the quality of the surrounding area where the diesel generator set is used, because the pollutants in the tail gas of the diesel generator include nitrogen oxides, carbon monoxide, particulates, sulfides, etc. Therefore, the tail gas of diesel generator set must be treated.

常規做法是引進旋流板水洗噴淋法，引進旋流板式噴淋塔，氣體在塔內由下向上高速運動，與自上向下噴出的洗滌液相接觸，由于塔內設置了多層旋流板，它能增加氣液接觸面積和接觸時間，使尾氣與水在塔內和板面上充分接觸。尾氣中的污染物質碳黑在與噴淋水接觸過程中，被水充分吸附，得以凈化；尾氣中NOx、SO2等氣態污染物通過在噴淋水中加入一定比例的NaOH使噴淋水呈堿性，在噴淋過程中，水與尾氣接觸時，發生化學反應，使NOx、SO2等氣態污染物得到中和達到良好的處理效果。在整個尾氣凈化過程中設備無需清洗，所用的噴淋水可循環使用，可實現自動控制，使用簡便。

The conventional approach is to introduce the vortex plate water washing spray method and the vortex plate spray tower. The gas moves at high speed from bottom to top inside the tower and comes into contact with the washing liquid sprayed from top to bottom. Due to the installation of multiple layers of vortex plates in the tower, it can increase the gas-liquid contact area and contact time, making the exhaust gas and water fully contact inside the tower and on the plate surface. The carbon black, a pollutant in the tail gas, is fully adsorbed by the water during Contact process with the spray water to be purified; Gaseous pollutants such as NOx and SO2 in the exhaust gas are treated by adding a certain proportion of NaOH to the spray water to make it alkaline. During the spray process, chemical reactions occur when the water comes into contact with the exhaust gas, resulting in the neutralization of gaseous pollutants such as NOx and SO2 and achieving good treatment results. During the entire exhaust gas purification process, the equipment does not need to be cleaned, and the spray water used can be recycled and automatically controlled, making it easy to use.

1、柴油發電機尾氣處理工程的設計建設，除應遵守本技術規范外，還應滿足國家現行的相關強制性規范的。

1. The design and construction of diesel generator tail gas treatment project shall not only comply with this technical specification, but also meet the current national mandatory specifications.

2、應根據企業柴油發電機尾氣中氣體污染類、濃度及處理要求等條件確定柴油發電機尾氣處理工程的處理規模和處理工藝，做到、經濟合理、技術可靠。

2. The treatment scale and process of diesel generator tail gas treatment project shall be determined according to the gas pollution type, concentration, treatment requirements and other conditions of the enterprise's diesel generator tail gas, so as to achieve economic rationality and reliable technology.

3、處理工程技術方案的選擇應滿足影響評價報告書批復文件的要求，柴油發電機尾氣處理后應穩定達到有關國家和地方排放規范的。

3. The selection of treatment engineering technical scheme shall meet the requirements of the approval document of the impact assessment report, and the tail gas of diesel generator after treatment shall meet the relevant national and local emission standards.